18 April 2012

Fitting Bathroom Accessories To Tiled Walls

Fitting Bathroom Accessories To Tiled Walls

Towel Rings, Toothbrush Holders, Soap Dishes Etc

Bathroom accessories are often ground into the other, and are ideal for adding that finishing touch to your bathroom makeover coordinated and useful functions. Things like toilet paper holders and towel rings are usually on the wall in the brackets that attach directly bolted to the wall. Or the mounting clip may be part of the installation, which makes it easier to assemble. When drilling holes in the wall, be careful, for tubes and pipes.

A special method must be used to fit the walls of the accessories tile to prevent damage to the tiles. As with hollow or solid walls, you must use the correct type of screws for the surface and is necessary to drill specially designed bricks that used to be strong enough to go through the tile. Take accurate measurements and make sure the holes in the correct position, since it can not fill and paint over as plaster on the walls.

As a general rule, it is advisable to fit the console in a central position, because the tile is more likely to be closer to the edges of the hole made in cracking. Keep your assembly in the selected position, use a highlighter to mark the screw holes in the tile. Before you gave birth, not covered by felt-tip markers with tape - needs to consider the situation with them for the band. The tape stops contributing to the drill slippage and scratching of the surface. With a bit of tile, making a bit on the surface with a low speed, before entering the increased speed in the wall. If possible, keep the vacuum cleaner nozzle into the hole as you drill down to prevent dust everywhere, and keep the grout sealer and always stained.

If you made the holes, remove the tape and put plugs in the holes. Place the connector and tighten with a screwdriver by hand, so you have more control. To maintain the waterproof surface of the tiles, put some silicone sealant to the end of each screw before screwing in. Finally, you can unscrew the cap to hide the appropriate mechanism. As this depends on the design meets their special accessories - a screw or bolt.
Related Posts Plugin for WordPress, Blogger...